How-to: Print & Cut
First Cut

How-to: Print & Cut

Print & Cut designs are made specifically to print onto your chosen material using your home printer and then cut out with your Silhouette machine. The designs have red cut lines included around the outside of the printed area. Just remember that your Silhouette machine does not print! Check out this tutorial for detailed instructions on how to work with Print & Cut designs.

Supplies Needed:

1. Open your Print & Cut design in Silhouette Studio®. Make sure your workspace matches the size of paper you will be printing on.

2. To add registration marks, click on the Page Setup icon located along the right-hand toolbar and select the style of registration marks. Type 1 is standard (which is what you will most likely use), and Type 2 is for older machine models.

3. You will note that there are now crosshatched areas on three corners of your workspace. Make sure that your design does not overlap into the crosshatched area or else your Silhouette will have trouble reading your registration marks.

4. Once your design is ready to go, print your job to your regular printer by clicking on the Print icon in Silhouette Studio®. Make sure you have loaded your material, whether it is cardstock or a specialty material, into your home printer correctly. Here we are using white sticker paper.

5. Load your printed material into your Silhouette using a cutting mat. Select the appropriate material from media list in the Send tab and adjust your blade accordingly (unless you use a machine with an AutoBlade).

6. Click “Send,” and your Silhouette will begin scanning the page for the printed registration marks. After the registration marks are found, the Silhouette will proceed to cut as usual.

7. Unload your material and complete your project.

A Print & Cut image has two parts: a design you will print with your home printer and corresponding cut lines you will cut with your Silhouette. Though the cut lines will show in Silhouette Studio®, they will not be printed. In addition to regular printer paper and cardstock, there is a large selection of Silhouette materials that can be used with the Print & Cut feature, including printable heat transfer material, printable foil, printable sticker paper, printable magnet paper, printable tattoo paper, and printable adhesive kraft paper.

Are you using metallic materials for a Print & Cut? We suggest leaving the registration marks at the default settings and increasing the thickness to the max.

If your machine fails to read your registration marks, you can choose to “retry manually” in the Send panel. Use the arrows to position the carriage above the marks and select “Register.” After the machine registers the mark, it will cut like usual.

Silhouette

Products Used:

Sticker Paper - Rose Gold Foil

Subscribe:

Join our Silhouette community and never miss an update!

We do not give your information to third parties, so your email address is safe with us.

Leave a Reply