12 Days of Christmas : 3d Sleigh

This 3d sleigh makes for a darling Christmas tree ornament… 

or, a treat container. If you opt for filling it with treats I recommend cutting out 2 of each side pieces so it’s a little more sturdy to hold the weight of what’s inside. 

Thanks for stopping by and enjoy what’s left of your weekend!

8 thoughts on “12 Days of Christmas : 3d Sleigh

  1. Michelle says:

    There is no link.. is it in the store??

    1. Kelsey says:

      Yes, it is under the 12 days of Christmas page. Happy holidays. Happy crafting.

  2. cema1cema says:

    This is so cute!! Thank you!!
    Christina

  3. Unknown says:

    Oh my goodness… Way cute!!! Thank you (again) sil gang… xoxo

  4. Val says:

    So cute….but I couldn’t get my Silhouette to cut this properly….after 4 tries and using all the 12 x 12 card stock I had, I finally got it to cut on 8.5 x 11 inch card stock. I’m not sure why, but my Silhouette does not like 12 x 12 cs! It is so cute though!!

  5. Kelsey,
    Do you use a specific brand of paper? I was using all sorts, then people recommended AC cardstock, but it tears at the corners as well. Thoughts? I tried cutting this and got snagged corners or not cut through all the way.

    It’s very cute, and I can’t wait to cut it out.

    1. Val says:

      I usually use either Bazzill or Stampin’ Up cardstock, but haven’t tried the AC cardstock. I just bought some, so I’ll have to try it. Thanks for the suggestion!

  6. G-ma says:

    Thank you for the cut file…will create this next year.

    Carolyn

Comments are closed.